Alan Site Admin

Joined: 29 Jan 2006 Posts: 1399 Location: Winnipeg, MB
|
Posted: Mon Dec 04, 2006 9:35 am Post subject: Watercooling a Laptop |
|
|
"Most laptops have an integrated cpu cooler block/ heat sink.
Remove this and figure out how to get water through it.
The compaq has a single copper pipe across the top. I cut a section of it off. Then cut off the end. Then I removed the copper mesh inside.
Then I flared the ends of the tube.
Then I stuck tubing on them by heating them gently and stretching them over the pipe. I borrowed this method from Bard Lund Johansen.
The tubes are also glued/caulked on using a 'household welder' adhesive.
Just for good measure a short (1/2 inch) length of 5/16 tube was slid over the top to keep it all snug."
http://www.instructables.com/id/EDZO09MXA3EV2Z4CFS/?ALLSTEPS
 |
|