FAQFAQ   GalleryGallery   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   Forum RSS Feed   Hacked Gadgets Main Site 

Photo Etch Circuit Board Process

 
Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Electronic Resources
View previous topic :: View next topic  
Author Message
Alan
Site Admin


Joined: 29 Jan 2006
Posts: 1399
Location: Winnipeg, MB

PostPosted: Sun Jun 25, 2006 5:07 pm    Post subject: Photo Etch Circuit Board Process Reply with quote

This article goes through the steps required to photo etch your own copper clad circuit boards. There is a relatively small amount of hardware that is required and the steps are quite simple. If you have done the toner transfer method in the past why not move to the next level?

http://hackedgadgets.com/2006/06/24/photo-etch-circuit-board-process/

Back to top
View user's profile Send private message Send e-mail

Display posts from previous:   
Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Electronic Resources All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Powered by phpBB © 2001, 2005 phpBB Group