FAQFAQ   GalleryGallery   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   Forum RSS Feed   Hacked Gadgets Main Site 

Op-amp regulator designs

Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Electronic Resources
View previous topic :: View next topic  
Author Message
HG Master

Joined: 12 Oct 2007
Posts: 119
Location: Gig Harbor, WA

PostPosted: Fri Jan 18, 2008 3:40 pm    Post subject: Op-amp regulator designs Reply with quote

Here are two regulators that I designed for my SMPS project (which I will post when I get the time to write everything and tweak it) but found out they were not needed. They however might be useful for some people.

( The resistors with the wire going through them are ment to represent the variable resistors. Additionally, The +/-50V is to represent a high voltage power source. Plus, the + and - signs are used to represent how you would attach a device to it. And finally, I just used 12V as my standard reference voltage when designing these circuits but can be replaced with other voltage outputs the op-amp can handle. )

This first one was for my boost converter. Since the voltages are greater than the op-amp's, the circuit in my prevous topic posted would not work. It works by using an Class A amplifier, which is an inverter, and the op-amp to counteract this invertion to make it regulate higher voltages than it can output or handle. I included an voltage divider to the sensor so that in voltage adjustment can be less to adjust the output voltage. If you want the voltages to be even greater than the op-amp's power output currently (which I set in the schematic to a multiplier of 2), change the resistors in the divider for the sensor. Wikipedia has a great equation to find the desired multiplier. I also changed the tranistor attacted to the design with a mosfet to save more power and be more efficent but a transistor will also work fine.

This second regulator was ment for my buck-boost converter. This one however caused be great fustration to make because I wanted the op-amp to run from the input voltage to ground. Since the buck-boost creates negative voltage, it caused the transistors to act in undesired ways. Thus I solved it with the circuit below. The secound op-amp is used to invert the negative voltage to a positive one (and also divide it by 2 thus causing to to multiply it to 2 times the input reference for the output) for the sensor to work. I also had to include a 10K resistor in the middle of the circuit to prevent the op-amp from dumping a positive voltage into the circuit to confisate for a lack of negative voltage when starting (and therefore stopped the positive voltage from preventing the negative voltage from building). This circuit can also be adjusted to have higher outputs by the divider (which does not follow the voltage divider equation but rather the divided amount of the higher by the lower).

If you are going to be working with voltages over 100 volts, I suggest that you increase the resistor values so you can save more current if it is restricted to a limited amount

Both these circuits worked great in my simulator and I'm sure someone here would find them useful. Did I mention that they where a pain to design from scratch and were just additional junk to my other SMPS circuits Evil or Very Mad
Back to top
View user's profile Send private message Send e-mail

Display posts from previous:   
Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Electronic Resources All times are GMT - 6 Hours
Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group