FAQFAQ   GalleryGallery   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   Forum RSS Feed   Hacked Gadgets Main Site 

How to run an Plug-in «Endurance Laser» for Inkscape

 
Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Laser Projects
View previous topic :: View next topic  
Author Message
ENDURANCEROBOTS
HG Contributor


Joined: 04 Jun 2016
Posts: 29

PostPosted: Mon Jun 20, 2016 5:38 pm    Post subject: How to run an Plug-in «Endurance Laser» for Inkscape Reply with quote

How to run an Endurance Plug-in «Endurance Laser» for Inkscape.

Select a vector image (a set of contours) with the selection and transformation tool (a black arrow).

FILLS

Start with "Contour object."
Next, select the plug-in extension «Right G-Code» and then «G-Code ...».
The first tab: basic code and commands setting.
The second tab: setting of the curves and lines approximation accuracy with G-code commands.
The third tab: Hatching settings. Angle: Hatching angle in degrees from the horizontal axis counterclockwise. Distance: hatching pitch in microns (1/1000 mm).
The fourth tab: Display settings. Warning: in this version the file with the results is overwritten when the plug-in starts anew.
Two radio buttons Process and Generate:
Process: Only contours – process the G-code of the image contours
Process: Only fills -- process the G-code of the image fills
Process: Both contours and fills
Generate: Only lines - display all the processed lines (under the G-code)
Generate: Only G-code - write the processed G-Code to a file
Generate: Both lines and G-code
Result – the fills should be converted into the G-code, if it was not preset in the plugin settings.
Note: To create a stamp cliché:
• the vector version of the stamp imprint should be mirrored;
• create an outer circle for the stamp imprint, which will be burnt through for further cutting out of it a stamp.

You may download a plug-in on EnduranceRobots.com or Endurancelasers.com web sites.

Cool video about how to run a plug-in you may watch on our channel:
https://www.youtube.com/channel/UCzziBor2UytyKZ2RCPjXvCA
Back to top
View user's profile Send private message AIM Address

Display posts from previous:   
Post new topic   Reply to topic    Hacked Gadgets Forum Index -> Laser Projects All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Powered by phpBB © 2001, 2005 phpBB Group