wizzdome Newbie
Joined: 18 Jun 2010 Posts: 1
|
Posted: Fri Jun 18, 2010 11:11 am Post subject: Bluetooth project... could use some feedback... |
|
|
Ok first I will explain what I have done then explain what i need help with. If you have any ideas I would appreciate the feedback!!!
Now I bough a cheap little stereo bluetooth set from bestbuy for $60 sounds pretty good as long as you keep the volume down a notch and the over the ear headphones were uncomfortable. First thought was earbuds would be more practical being that i listen to music at work from my phone with it... I had a pair of Koss headphones that are the ones that go in your ear like an earplug and have excellent sound.... Ok so i cut them to to fit from the headphones hanging on my neck to my ears... then my mic went out on me and i replaced it... I then decided that the headphones hanging on my neck was not practical though the sound was great... I took them off of the headset removed the speakers which were cut out of the equation with the headphones... Having mic issues again but think i just need a better bit of wire to run to it...while removing the speakers i decided to make a pendant out of it and glue the two sides together... i think it looks rather nice this way i took a small piece of rope and put a hook at the end of it so it can be put on and taken off of a necklace easily... My beaded necklace broke...it was my bluetooths fault so i put the beads on my headphone wires to give it a cool look...
Here is my issues... The mic sounds crappy think i need better wire to solder to it... power is becoming a major issue the battery before could run a full 12 hour shift including to work and home again... Now I am lucky to get 4 hours out of it though after charging for 2 hours seems to still run fine... I would really like to get back the 8 hours i lost but i figure the earbuds are the cause of the battery drain as they do have a much better sound to them... Any suggestions would be helpfull if you need any more info let me know...
 |
|